1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1
i n f o @ v i n o t e m p . c o m
INSTALLATION
Remove all packing material before using your wine cooler.
IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water and a soft cloth.
This unit is designed for freestanding installation and indoor use only. Position the unit in a dry and
well-ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in direct
sunlight. Do NOT install the unit in a location with an ambient temperature that will fall below 60°F.
For freestanding installation, 6” of space at the back, 10-12” of space on each side, and unlimited
clearance at the top of the wine cooler are suggested to ensure proper air circulation to cool the
compressor and condenser. Do not place underneath a table, counter top, or anything of the sort as
this will not allow for proper air circulation.
Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To level
the wine cooler, adjust the front leveling legs at the bottom of the wine cooler.
For best performance it is recommended that you install the appliance in a location with an
ambient temperature between 60°-90°F. If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected.
Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.
OPERATING YOUR WINE COOLER
CONTROLS
Power
To turn the appliance ON or OFF, touch the and at the same time for 5 seconds.
Set
Set or view the internal temperature setting for each zone.
Light
Turn the inner light ON or OFF.
Up
Raise the set temperature by 1°C or 1°F.
Down
Lower the set temperature by 1°C or 1°F.
ºF/ºC Selector
Choose to display temperature setting in Fahrenheit or Celsius. To change the temperature display from
Fahrenheit to Celsius or from Celsius to Fahrenheit, touch and hold for 5 seconds.
Key Lock
After 2 minutes of inactivity, the controls will be locked automatically. To release the lock, touch the
and at the same time for 5 seconds.
(17 Seiten)
(1 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern