wwwwww..wwiinneemmaattee..ccoomm Duct Split Cooling System Installation, Operation & Care Manual WM-2500SSH WM-4500SSH WM-6500SSH WM-8500SSH
- 9 -In case there is excessive frost, the parameters FnC = C-y, idF =
- 10 -Care Guide In general, always unplug system or disconnect pow
- 11 -User’s Troubleshooting This Troubleshooting Chart is not prepar
- 12 -high or not cooling and running continually b. Cellar too lar
- 13 -fan running but condensing unit not running b. Failed components
- 14 -high ambient temperatures or airflow restriction d. Defective co
- 15 -Installer’s Instructions Federal law requires that WINE-MATE sp
- 16 -CAUTION: Liquid and suction line locations may differ from what
- 17 - Fig. 4 WM-250~450SCU Condensing Unit Fig. 5 WM-650~850SCU C
- 18 - F
- 1 -Important Safety Information WARNING: • Do not use a ground fau
- 19 - Model No Insulated Duct WM-2500SSH 8” WM-4500SSH 8” WM-6500SSH
- 20 - BACK POSITION FRONT POSITION
- 21 -B. PS2 Dual Control Fig. 11 Adjustable Pressure Control 2)
- 22 - Fig. 13 Condenser Fan Cycle Control B. Use of the crankcase
- 23 -The line sizes and refrigerant charges are listed as follows. M
- 24 - Fig. 14 Fan Speed Control 2) The subcooling at the condensin
- 25 -10. Pressure, Superheat and Subcooling Readings CAUTION: To re
- 26 -Electrical Wiring Diagrams CAUTION: • Hidden lines are the fi
- 27 - Fig. 17 WM-6500SSH Electrical Wiring Diagram Fig. 18 WM-850
- 28 - Fig. 19 Low Ambient Temperature WM-2500~4500SSH-LA Electrical
- 2 -Table of Contents Cellar Construction.…………………………….……………..3 Fea
- 29 - Fig. 21 Low Ambient Temperature WM-8500SSH-LA Electrical Wirin
- 30 -Customer Support If you need further assistance, please contact
- 31 -Warranty Thank you for choosing a Vinotemp cooling unit. Ple
- 32 -VINOTEMP will, at its discretion, repair or replace the unit and
- 3 -Cellar Construction This is only a guide and shall be considered
- 4 -Features and Specifications • Wine-Mate duct split cooling syst
- 5 -NOTE: To prepare rough-in, leave minimum 4” clearances for electr
- 6 -Temperature and Humidity 1. The controller Fig. 2 TEMPERATURE C
- 7 -4) Alarm Signals The alarm codes are described as follows. MES
- 8 -6. Parameter Programming 1) Press and hold the SET + keys until
Kommentare zu diesen Handbüchern