Vinotemp WINEMATE WM1500 SSW Spezifikationen

wwwwww..wwiinneemmaattee..ccoomm Wall Split Cooling System Installation, Operation & Care Manual WM-1500SSW WM-2500SSW wwwwww..vviinnoottee

- 9 -In case there is excessive frost, the parameters FnC = C-y, idF =

- 10 -Care Guide In general, always unplug system or disconnect pow

- 11 -User’s Troubleshooting This Troubleshooting Chart is not prepar

- 12 -high or not cooling and running continually b. Cellar too lar

- 13 -fan running but condensing unit not running b. Failed components

- 14 -high ambient temperatures or airflow restriction d. Defective co

- 15 -Installer’s Instructions Federal law requires that WINE-MATE sp

- 16 -CAUTION: Liquid and suction line locations may differ from what

- 17 - Fig. 4 WM-150~250SCU Condensing Unit

- 18 -2) Air supply shall be unobstructed minimum 12” for a direct blo

- 1 -Important Safety Information WARNING: • Do not use a ground fau

- 19 - BACK POSITION FRONT POSITION

- 20 -A. Use of the crankcase heater The crankcase heater is install

- 21 -difference is more than 10 ft or the line set exceeds 75 ft, use

- 22 -clockwise to increase the minimum speed. The minimum speed shoul

- 23 -10. Pressure, Superheat and Subcooling Readings CAUTION: To re

- 24 -Electrical Wiring Diagrams CAUTION: • Hidden lines are the fi

- 25 - Fig. 14 Low Ambient Temperature WM-1500~2500SSW-LA Electrical

- 26 -Customer Support If you need further assistance, please contact

- 27 -Warranty Thank you for choosing a Vinotemp cooling unit. Ple

- 28 -VINOTEMP will, at its discretion, repair or replace the unit and

- 2 -Table of Contents Cellar Construction.…………………………….……………..3 Fea

- 3 -Cellar Construction This is only a guide and shall be considered

- 4 -Features and Specifications • Wine-Mate wall split cooling syst

- 5 -NOTE: To prepare rough-in, leave minimum 4” clearances for electr

- 6 -Temperature and Humidity 1. The controller Fig. 2 TEMPERATURE C

- 7 -4) Alarm Signals The alarm codes are described as follows. MES

- 8 -6. Parameter Programming 1) Press and hold the SET + keys until